The Global Leader In Viscosity For Over 75 Years
Brookfield AMETEK



Determination of Curd Strength.


Determine strength of curd as an aid in grading the quality of tofu and other curd products.


Curd sample to be tested is placed on test table. The curd probe kit consists of three probes used to compress the sample until it ruptures. The curd strength is defined as the peak load at rupture.


Tofu curd strength testing has traditionally been performed using a motorized stage to lift the curd sample toward the test probe, which would unload a weighted spring causing the probe to apply increasing force on the sample. The operator was required to watch a mechanical pointer as it moved over a scale of 0-100 until it suddenly collapsed as the probe punctured the sample. The highest scale reading observed was taken to be the curd strength.

Due to the limited load range of this machine, probes of three sizes were necessary. The small 5mm diameter probe was used to test extra firm curd. This allowed a moderate load on the probe to apply a relatively high stress on the sample. On the other hand, the 10mm diameter probe was used to test soft curd. This allowed the relatively low stress at rupture to result in a moderate load on the probe. The development of 10mm, 8mm and 5mm diameter probes was therefore necessary. Using a 1000g Load Cell provides sufficient capacity to test all three types of curd with one probe. Three curd probes are provided to allow easy correlation with existing methods. This allows a seamless transition to modern equipment without the need to change criteria for firmness grades.


The "trigger value" is the load in grams, which must be exceeded to begin the test. This is used to indicate the position of the sample surface and allows the test to begin. After triggering, the probe will travel to the target distance at the preset speed.

When setting the target distance for the test, sample thickness must be considered as well as the expected deformation to rupture. A soft curd product 40mm thick might rupture after only 10mm of penetration, whereas an extra firm product with the same thickness might deform 20mm before rupturing. The target distance must be set sufficiently high to exceed the deformation required for rupture.


  • TEST: Normal
  • TRIGGER: 3g
  • DISTANCE: 40mm*
  • SPEED: 4mm/s
  • * varies by sample


Mechanical Scale 10 20 30 40 50 60 70 80 90 100
Reading in grams 21 41 62 83 104 124 145 166 186 207


In order to obtain accurate curd strength results for tofu puncture, test probes of specific geometry and dimensions are required. Typically, a test of extra firm tofu uses the 5mm diameter probe TA46. A test for firm tofu would use the 8mm diameter TA47 probe, and the test for soft tofu would use the 10mm diameter probe TA48. These probes, when used with the CT3, provide results identical to those used in the traditional mechanical method described above, with one exception. The mechanical scale range of 0-100 is equivalent to 0-207g. The Texture Analyzer reads directly in grams, so the expected results must be correlated according to the table above.


The modern, user friendly, low cost texture analyzer, Model LFRA, can be used for Quality Control testing of tofu and other curd products. A set of Curd probes is the only items necessary to complete the system.